High performance Intake Manifold (32mm stud spacing)
Billet Aluminum Ported
Includes o-ring and hardware
*Gasket sold separately
-
Less restrictive
flow path from the carburetor
to the engine.
-
Improved
performance.
-
O-Ring seal
eliminates vacuum leaks that
cause poor idle quality.
-
CNC machined to
closely match the intake
port on most engines.
Fits on most 48/66/80cc bicycle engine kits, it is designed for greater gas flow efficiency as well as an O-ring seal for a nice air tight fit that helps prevent any vacuum leaks that normally cause poor idle quality and bogging. (19mm O.D. where it clamps onto the intake manifold)
Will also fit a 2009 Grubee GT5 that has the 32mm spacing. Grubee GT5 with CNS carb.
The original gasket partly blocks the intake port. DO NOT USE ORIGINAL GASKET!
Gasket material (Available at auto parts stores), do not use cork!...Pliers to remove factory intake mounting studs.
Remove stock intake using a 10 mm open end wrench. Remove the mounting studs.
Make a new gasket by tracing around the original or For $4.25 Purchase properly formed new gasket under (Miscellaneous Parts)
**Note : When using this intake with a performance carburetor it needs to be level to get the expected performance**