 |
This size is generally for front tube diameters. Always measure! Some require reducer bushings for non-standard diameters. For 6mm studs with 1-1/2 - 2" stud spacing's only! What you get (1) single engine mount. Select front or rear!
The front engine mount (T-bracket) mounting component has 2 slots to
adapt to any of the Chinese engines with M6= 6mm front studs with 1.5"-2" spacing configurations. **Some engines have wider stud spacing, 2.25" spacing between the studs. With 8mm or M8 studs. These would require the wide (T bracket) mounting component available in Miscell. Parts on navigation menu of home page.
The rear engine mount (T-bracket) mounting component has 1 hole and 1 slot. (For 6mm studs) This is because the drive sprocket is very close to one of the mounting studs on the rear mount application. So the rear (T-bracket) mounting component that has the hole will mount on the stud nearest to the drive sprocket.
SELECT FRONT OR REAR IN OPTIONS WHEN ORDERING! To be sure you get the proper (T-bracket) mounting component! The frame clamps are interchangeable
**Compatible with all Chinese motors that have 6mm studs and 1-1/2 - 2" stud spacing between the studs**
Benefits:
-
Easy, fast, secure,
engine installation.
-
Eliminates, annoying,
broken fasteners.
-
Designed and CNC machined to
match your engine and bicycle frame geometry. - Available for a variety of frame tube diameters 1_1/8", 1_1/4" and 1_1/2".
Highly recommend also getting loctite under (Miscellaneous parts) **The mounts DO NOT come with mounting bolts because they vary in size. The mounting studs are usually M6 = 6mm If so, replace the mounting studs with a M6 allen bolt
If you need a custom diameter smaller than 1_1/8" we can make you a custom reducer bushing for $30.00 Must
call in to order the custom reducer bushings 727-551-1435
Official Manic Mechanic part
|
|
 |